Dometic GROUP WAECO MagicComfort MSH60 Instrucciones De Montaje Y De Servicio página 24

Installing the seat heater
NOTE
I
To bridge the stitching recesses or the cross braces with which the
seat cover is additionally secured to the foam core, a recess is pro-
vided on the heating element of the seat surface.
➤ Depending on the seat, guide this area through the stitching recess
(fig. a, page 5) or place this area through the recesses in the tunnel for
the cross braces.
➤ Fasten the heating element using double-sided adhesive tape to prevent
it sliding on the foam core.
Ensure that no creases or kinks form.
Installing the heating element for the backrest
➤ Open the lower area of the backrest cover (fig. b, page 5).
➤ Push the heating element into the gap between the seat cover and the
seat cushion (fig. c, page 5).
➤ Fasten the heating element using double-sided adhesive tape to prevent
creases.
NOTE
I
The heating surface only needs to extend approx. 30 – 35 cm
above the seat, as the driver, when sitting normally, leans against
this area only.
If the seats are equipped with side airbags, then there is a prede-
termined breaking point in the cover fabric. The seat cover must
therefore not be pulled tightly or slip out of place.
Installing the seat
➤ Lift the seat into the vehicle.
➤ Secure the vehicle seat with the fastening screws.
24
MagicComfort MSH60, MSH601
EN