Dometic GROUP WAECO MagicComfort MSH60 Instrucciones De Montaje Y De Servicio página 23

MagicComfort MSH60, MSH601
6.2 Installing the seat heater
The seat heater MagicComfort MSH60 includes heating elements for the
driver's and passenger seats; the seat heater MagicComfort MSH601 only in-
cludes heating elements for the driver's or passenger seat.
Removing the seat
➤ Secure the vehicle against rolling away.
NOTICE!
A
For vehicles with side air bags in the seat backrest, observe the
manufacturer's instructions on removing the seats and the uphol-
stery.
➤ Check the suitability for installation using these installation instructions
and the manufacturer's information.
➤ Remove the fastening screws from the vehicle seat.
➤ Lift the seat out of the vehicle.
Preparing the seat
➤ Remove all plastic panelling from the seat to ensure the fastening of the
cover fabric can be reached.
➤ Separate the backrest from the seat (fig. 5, page 4 and fig. 6, page 4).
➤ Open the seat cover on the seat surface.
The cover fabric is usually tucked into a seam on the frame with a wide
cardboard strip or metal wire.
➤ Remove the fasteners using a screwdriver and pliers (fig. 7, page 4 and
fig. 8, page 5).
➤ Remove any upholstery staples or cross braces (fig. 9, page 5).
Installing the heating element for the seat surface
NOTICE!
A
The heating cables must not be damaged or bent sharply. In case
you need to make cuts in the heating element, pay attention to the
routing of the heating cables.
➤ Insert the heating element for the seat surface between the cover fabric
and the foam core of the seat (fig. 0, page 5).
EN
Installing the seat heater
23