IMG STAGELINE PARL-32DMX Manual De Instrucciones página 12

Caution: The unit must not be connected to the
GB
mains voltage via a dimmer!
For a more convenient operation it is recommended
to connect the unit to a socket which can be
switched on and off via a light switch.
5 Operation
5.1 Operation without DMX control unit
5.1.1 Music-controlled programmes
1) Press the button FUNC (2).
2) Select the function
DOWN and confirm with the button ENT.
3) Select the desired control programme with the
button UP or DOWN and confirm with the button
ENT. The display (3) shows the programme:
The lighting colour is changed by music
control (mixed colours only).
Music-controlled stroboscope with colour
change (mixed colours only)
Music-controlled stroboscope with colour
change (primary colours and mixed
colours)
The lighting colour is changed by music
control (primary colours and mixed
colours).
If the music is played with a clear rhythm in the
bass range at sufficient volume, the selected pro-
gramme is controlled via the microphone (9). Adjust
the control SOUND SENS (8) for the microphone
sensitivity so that the dynamic power of the music
is reproduced by the unit in an optimum way. For
programmes
matically changed during music breaks after a few
seconds.
5.1.2 Programmes running automatically
1) Press the button FUNC (2).
2) Select the function
DOWN and confirm with the button ENT.
3) Select the desired control programme with the
button UP or DOWN and confirm with button
ENT. The display (3) shows the programme:
The lighting colour is changed automat-
ically after approx. 5 s in each case.
Automatic colour change with slow fad-
ing in and out
Automatic colour change with slow fad-
ing in and then immediate colour change
12
with the button UP or
and , the colours are auto-
with the button UP or
Automatic crossfading of different
colours
same as
Automatic colour change with slow fad-
ing out in each case.
5.1.3 Colour spotlight with selectable colour
1) Press the button FUNC (2).
2) Select the function
DOWN and confirm with the button ENT.
3) Select the desired colour with the button UP or
DOWN and confirm with the button ENT. The
display (3) shows the number of the colour:
white
red
green
blue
purple
cyan
yellow
pink
orange
light green
5.2 Interconnection of several
PARL-32DMX units
Several PARL-32DMX units may be interconnected
(master-slave operation). Then all slave units can
be controlled in sync with the master unit.
1) Connect the DMX OUT (6) of the master unit via
a 3-pole XLR cable (e. g. series MEC-... or
MECN-... from the product range of MONA-
COR) to the DMX IN (5) of the first slave unit.
2) Connect the DMX OUT of the first slave unit to
the DMX IN of the second slave unit, etc. until all
units have been connected in a chain.
3) No DMX signal must be present at the DMX IN
of the master unit. Adjust the slave units to the
DMX address 001 (
Once the control signals from the master unit are
present at the slave units, they are controlled by the
master unit and the dot behind the first position on
the display (3) flashes. If a slave unit does not
receive any control signals, the indication
appears on its display.
with the button UP or
chapter 5.4.2).