Remote Control Lc-3; Safety Notes - IMG STAGELINE LED-32C Manual De Instrucciones

GB
AUTO =
14 Button STROBE for the stroboscope function
The flash frequency can be adjusted with con-
trol STROBE SPEED (16).
15 Button BLACK OUT
– turns off the LEDs of the connected units
– if the button is pressed again, the previous
brightness reappears
– to switch the control from the remote control
LC-3: keep the button pressed until the LED of
button BLACK OUT starts flashing
16 Control STROBE SPEED to adjust the flash fre-
quency (1 — 20 Hz)
17 Control CHASE SPEED to adjust the speed
when a sequence of scenes is running automat-
ically (duration per scene 0.1 s to 60 min.)
18 Control FADE to adjust the fading speed when a
sequence of scenes is running automatically
(0 – 100 % of the running speed)
19 Connection jack for the remote control LC-3
20 Microphone for music control
21 DMX signal output for connection of a DMX LED
spotlight;
pin 1 = ground, 2 = DMX-, 3 = DMX+
22 Connection jack for the supplied power supply
unit
23 On / off switch

1.2 Remote control LC-3

The remote control is available as an accessory
and is not supplied with the control panel.
24 Button STAND BY for the function BLACKOUT
= to turn off spotlights
25 Button FUNCTION for different functions de-
pending on the operating mode selected with
button MODE (26)
26 Button MODE to switch between
– stroboscope (the LED of the button does not
light up)
For the stroboscope function keep button
FUNCTION pressed
– music-controlled run of a sequence of scenes
(the LED of the button lights up)
Select the desired sequence of scenes with
button FUNCTION
– manual run of a sequence of scenes
(the LED of the button flashes)
Advance the sequence of scenes with button
FUNCTION.
12
Adjust the sensitivity of the music
control with the buttons
the sequence of scenes is running
at the speed adjusted via the con-
trol CHASE SPEED (17).

2 Safety Notes

and (4).
The units (control panel and power supply unit) cor-
respond to all required directives of the EU and are
therefore marked with
WARNING The plug-in power supply unit is sup-
It is essential to observe the following items:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water,
high air humidity, and heat (admissible ambient
temperature range 0 – 40 °C).
G
Do not set the control panel into operation, and
immediately disconnect the power supply unit
from the mains socket if
1. there is visible damage to one of the units,
2. a defect might have occurred after a drop or
similar accident,
3. malfunctions occur.
The units must in any case be repaired by skilled
personnel.
G
For cleaning only use a dry, soft cloth, never use
chemicals or water.
G
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they
are not correctly connected or operated, or not
repaired in an expert way.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.
.
plied with hazardous mains voltage.
Leave servicing to skilled personnel
only. This may cause an electric
shock hazard.