Bornay 600 Manual De Usuario página 68

Problem observed
Wind is strong and wind
turbine does not brake
with regulator brake
activated.
The regulator screen
shows nothing.
The regulator is
overheating
Battery voltage is too
high.
Battery voltage is too
high(continued)
Wind turbine vibrates
Possible cause
The wind is so strong
that the regulator brake
cannot brake the
machinery.
Battery is disconnected. Check wiring in
Defective printed circuit. Check connections on
Batteries too small
and/or too little
consumption.
Located in strong winds Functioning correctly,
Defective battery
connection.
The regulator is not
functioning properly.
Loose bolts
Bornay 600 – Rev 6.0 - P 68
Solution
Activate intermittent
brake until machinery is
stopped, using moments
when strong wind
abates.
continuous section and
check power is reaching
regulator.
printed circuit board. If
fault persists, contact
your supplier.
Revise size calculations
of your installation.
but you can put wind
turbine in braked mode
if batteries are charged.
Check battery
connection
terminals/elements.
Tighten screw
connections.
Contact your supplier.
Tighten bolts.