Bornay 600 Manual De Usuario página 55

Aerogenerador
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

If the wind is very strong, the wind turbine may not stop completely, although
the energy generated is diverted to the brake resistors.
NOTE: if the equipment is in AUTOMATIC BRAKING mode and we require the
wind turbine to return to its charge position without waiting for the battery
voltage to fall below the deactivation level, simply turn the switch (manual
braking) to ON position and then back to the OFF position, thus erasing the
automatic braking mode. The equipment will immediately generate energy again
if the wind is favorable, while the time and impulse counters will re-initiate.
Manual braking: When the switch is in ON position, a sequence of impulses is
initiated to brake the wind turbine until it stops completely or, in the event that
the wind is strong, until it slows to a minimum of revolutions.
When the manual braking switch is activated, this is indicated on the screen at
the end of the second line and the brake indication LED is also illuminated.
If the switch is put back to the OFF position, the wind turbine is immediately
freed and newly set to generate energy. The brake indication LED goes off.
This operation must be carried out periodically to verify the correct status of the
braking elements: if, in low wind conditions, the wind turbine does not brake
completely, the electric control box must be checked.
 WARNING:
Bornay 600 – Rev 6.0 - P 55

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

300060001500

Tabla de contenido