Oster 4281 Manual Del Usuario página 7

C L E A N Y O U R C O F F E E m A K E R
B E F O R E U S I N g T H E F I R S T T I m E
Make sure your first cup of coffee is as good as can be by cleaning your Oster
coffeemaker before its first use. Just follow these simple steps:
1 Wash the decanter, decanter lid and the filter basket in a mixture of mild
detergent and water. Rinse each thoroughly, please refer to the parts diagram .
2 Replace all the parts and close the lid.
3 Pour up to 1.8 liters (60 oz.) of cold, fresh water into the water reservoir.
Then, run a brew cycle with water only, without adding coffee and coffee filter.
4 When brewing is complete, turn your coffeemaker off, discard the water in
the decanter and rinse the decanter, decanter lid, and filter basket.
Your coffeemaker is now ready to use. Enjoy it!
S E T T I N g T H E C L O C K A N D D E L A Y B R E W T I m E
To Set the Clock:
1 Plug the power cord into a standard electrical outlet.
The clock will flash on the control panel to indicate that
the time has not been set yet.
2 Press and hold the HOUR and MINUTE buttons until
you reach the current time. The AM or PM indicator will
light on the display (Figure 1 and 2). If the buttons are
held down, numbers will cycle faster.
The clock is now set!
NOTE: Pressing any button before setting the clock
will cause the clock to start keeping time from
12:00 a.m. You must set the clock if you want to
use the Delay Brew feature.
To Set the Delay Brew Time:
Simply press the SET DELAY button (Figure 3) and, while
time is flashing, set the brew time by pressing the HOUR
and MINUTE buttons (Figure 4). The AM or PM indicator
will light on the clock display.
Within a few seconds the display will change to the
current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see the
"Brewing Coffee Later" section.
To check the programmed time, press the SET
DELAY button. The display will show the time you have
programmed the coffee to brew. If you press the SET
DELAY button again or wait a few seconds, the display will
switch back.
Audible Ready Signals: To turn off the Audible Ready
Signals press button until bell disappears on display screen
(Figure 5).
®
1
2
3
4
5
6