Setting Into Operation - IMG STAGELINE PAR-36/CR Manual De Instrucciones

1) For easy installing of the lamp place the
spotlight housing so that it is supported
by the mounting bracket (3) (see figure).
For this, slightly loosen the two knob
screws (2), place the mounting bracket
into the desired position, and tighten the
knob screws again.
2) Turn off the screw cover (6).
3) For a lamp replacement remove the col-
our filter (5) in case it has been placed on
the lamp, and take the old lamp carefully
out of the housing. Loosen the two screw
connections which make the electrical
contact between the lamp socket and the
connection cable of the lamp holder. Re-
move the old lamp.
4) Install the new lamp: slightly loosen the
two screws at the lamp socket, tightly
clamp one cable lug each of the connec-
tion cable below each screw, and tighten
the two screws again. Carefully place the
lamp into the spotlight housing.
5) If a colour filter (5), e. g. LEF-36SET from
"img Stage Line", is used, place same on
the lamp, and screw on the screw cover
(6) again.

5 Setting into Operation

1) Fix the unit via the mounting bracket (3)
with a support for light radiating units or a
stable mounting screw to the desired
place, e. g. to a traverse for light radiating
units or a stand.
2) For aligning the unit loosen the two knob
screws (2) at the mounting bracket, ad-
just the desired inclination of the unit, and
tighten the knob screws again.
3) Connect the plug of the mains cable (1) to
a mains socket (230 V~/50 Hz). With con-
nection to the power supply the spotlight
is switched on.
4) For switching off the unit disconnect the
mains plug.
6 Specifications
Voltage supply: . . . . . . 230 V~/50 Hz/40 W
Lamp insert:. . . . . . . . . PAR 36 lamp
Dimensions (Ø x D): . . 120 x 160 mm
Weight: . . . . . . . . . . . . 1 kg
According to the manufacturer.
Subject to change.
(6 V/30 W; socket:
2 x screw)
GB
7