Ryobi RTS10NS Manual Del Operador página 26

WARNING:
To reduce the risk of injury, always make sure the rip fence
is parallel to the blade before beginning any operation.
TO USE THE RIP FENCE
See Figure 26.
 Raise the locking lever on the rip fence.
 Place the rear lip on the rear of the saw table and pull
slightly toward the front of the unit.
 Lower the front end of the rip fence onto the guide surfaces
on top of the front rail.
 With the rip fence flat on the saw table, push the fence
towards the front rail to align the fence to the saw table.
 Push the locking lever down to align and secure the fence.
Check for a smooth gliding action. If adjustments are needed,
see To Check the Alignment of the Rip Fence to the Blade
in the Adjustment section of this manual.
 Make two or three test cuts on scrap wood. If the cuts
are not true, repeat the process.
NOTE: The rip fence must be secure when the locking
handle is engaged. To increase the grip of the rip fence on
the rear lip of the table, tighten the clamp nut on the rear
of the rip fence by turning it clockwise using an 11mm
wrench.
TO SET THE RIP FENCE SCALE INDICATOR
TO THE BLADE
See Figure 26.
Use the indicator on the rip fence to position the fence along
the scale on the front rail.
NOTE: The anti-kickback pawls and blade guard assembly
must be removed to perform this adjustment. Reinstall the
blade guard assembly when the adjustment is complete.
Begin with the blade at a zero angle (straight up).
 Unplug the saw.
 Loosen the rip fence by lifting the locking lever.
 Using a framing square, set the rip fence 2 in. from the
blade tip edge.
 Loosen the screw on the scale indicator and align with
the 2 in. mark as shown.
 Tighten the screw and check the dimension and the rip
fence.
OPERATION
LOCKING
LEVER
BLADE
2 in.
MARK
26 - English
RIP
FENCE
RIP
FENCE
2 in.
LOCKING
SCALE
INDICATOR
CLAMP
NUT
REAR
LIP
SCALE
FRONT
RAIL
LEVER
Fig. 26