Maintenance - Ryobi P320 Manual Del Operador

DIAGNOSTIC FEEDBACK
The LED Worklights provide feedback to indicate whether
the battery pack is charged sufficiently and/or if the tool is
functioning properly.
If worklights are flashing, install fully charged battery. If light
continue to flash, see Troubleshooting section for more
information.
REMOVING NAILS FROM THE TOOL
See Figure 11, page 13.
WARNING:
Remove the battery pack before removing nails or clear-
ing a jammed nail. Failure to do so could result in serious
personal injury.
 Remove battery pack from the tool.
 To remove a strip of nails from the tool, depress the maga-
zine release button located at the rear of the magazine
and slide the magazine open.
 Remove nails.
 Close the magazine.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION
REMOVING A JAMMED BRAD NAIL
See Figure 12, page 13.
 Remove battery pack from the tool.
 Open magazine and remove nails from the tool.
 Pull up on the latch and open the jam release.
 Insert a flat blade screwdriver into the tip of the driving
mechanism and push the driver mechanism back, freeing
the nail jam.
 Remove the bent nail.
 Close the jam release and latch.
 Reinstall nails and close the magazine.
 Reinstall the battery, reactivate tool.
NOTE:
or jammed nails may lead to a driver blade being stuck at
its bottom position.
The driver blade can usually be returned to its operating
position by depressing the work contact element against a
scrap piece of wood and squeezing the trigger.
If the tool cycles without driving a nail, the nail channel may
be dirty. See Cleaning the Nail Channel in the Maintenance
section of this manual.

MAINTENANCE

CLEANING THE NAIL CHANNEL
See Figure 13, page 13.
If the tool will not drive a nail, or cycles without driving a nail,
glue residue from the nail strip may need to be cleaned from
the area around the driving mechanism.
 Remove the battery pack.
 Remove nails from the tool.
 Open the jam release latch and the magazine.
 Use a small amount of air tool oil on a clean cloth or cotton
swab to wipe down the nail channel, removing all traces
of glue.
 Reinstall nails in the tool and close the magazine.
10 — English
Driving too deeply into the material, excess debris,