Assembly; Operation; Installing/Removing The Battery Pack - Ryobi PMP01 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
Keep water and mist discharge pointed away from all
electrical devices to reduce the risk of electrocution or
electric shock.
WARNING:
Ensure all hose connections are secure before using
misting kit. Spilled water and leaks can result in a slippery
surface and create a slip and fall hazard.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Always remove battery pack from the product when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Do not use this product to spray pesticides, liquid
fertilizers, chemicals, or any liquids other than clean
water. Spraying these substances could result in serious
injury or illness to the operator or bystanders.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the following purposes:
 Outdoor cooling while connected to a 5-gallon bucket or
garden hose
FLUSH THE SYSTEM AND TEST FOR LEAKS
To ensure the product functions properly, always flush and
test the system for leaks before use.
To flush the system:
 Remove end cap and nozzles.
 With the hose faucet turned completely off, attach a
garden hose (not provided) to the garden hose connector
and hand tighten.
 Turn faucet on and allow water to run through the garden
hose and misting tube for 30 seconds to wash away any
debris. Then turn faucet off.
To test the system:
 Replace end cap and nozzles.
 Turn faucet on fully and allow water to run through the
garden hose and misting tube to pressurize the unit.
NOTE: Make sure the faucet is turned on fully and that
there are no kinks or leaks in the hose.
 Check each threaded hole on the misting tube for leaks.
If leaks are present, refer to the Troubleshooting section
later in the manual.
PUMP ON/OFF SWITCH
See Figure 1, page 9.
The pump switch is located on the right front of the base.
 To turn the pump ON, press ( I ).
 To turn the pump OFF, press ( O ).
INSTALLING/REMOVING THE BATTERY
PACK
See Figure 2, page 10.
NOTE: This product is not recommended for use with RYOBI
ONE+ battery packs larger than 4.0Ah. If installed, large
capacity battery packs will prevent the battery cover from
5 — English