Replacing A Lost Or Broken Somfy Io Control Point; Restoring The Original Configuration; Technical Data - SOMFY PERGOLA io Manual Para El Instalador

8.2. Replacing a lost or broken Somfy io control point

Refer to the corresponding guide.
8.3. Restoring the original configuration
This reset deletes all control points, all the sensors and all the end limit settings, and resets the
motor's direction of rotation and favourite position (my). However, for tensioned Pergola awnings
only, the fabric tension setting is maintained.
Only switch off the power for the motor to be reset.
1) Put the awning in the middle position (if possible).
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on: the awning moves for
several seconds.
If the awning is at the upper or lower end limit, it will
move briefly.
6) Hold down the PROG button: the awning will make a
brief first movement followed by a second a few moments
later. The motor is configured with the factory settings.
- Repeat the procedures from the

9. TECHNICAL DATA

Radio frequency
Power supply
Operating temperature
Protection rating
Maximum number of associated control
points and sensors
Safety level
Copyright © 2010 Somfy SAS. All rights reserved.
Commissioning" section
868-870 MHz io-homecontrol®, two-way Tri-band
1 2
5 s
3 4
ON
15 s
5
ON
6
7 s 2 s 7 s
230 V ~ 50 Hz
- 20°C to + 70°C
IP 44
9
Class I
Pergola io
OFF
2 s
OFF
2 s
45