Foppapedretti SuperTres Manual De Instrucciones página 14

GB
ASSEMBLY
Important note: the images and instructions contained in this handbook refer to one version of the
stroller; some components and functions described herein may vary according to the version of the
stroller you have purchased.
INSTALL FRONT WHEELS (fig.1, fig.2, fig.3, fig.4, fig.5)
Insert the end bushing into the front legs until it is completely locked. Ensure the correct assembly.
Insert the end bushing into the slot situated in the center of the wheel block
Press the button down front wheel blocked. Raise the lock lever to activate the swivel function.
Press the steel button front wheel released (fig.5).
INSTALL REAR WHEELS (fig.6, fig.7, fig.8, fig.9, fig.10)
Assemble the rear wheels along the arrow direction.
Insert the rear wheel group into the end of the tubes of the rear legs. The wheel supports are
correctly assembled when the metal pins are locked in the corresponding holes on the tubes of the
chassis (fig.9).
Press the button situated on the center of wheel and pull it to take the wheel apart from the axle
(fig.10).
UNFOLD THE STROLLER (fig.11, fig.12, fig.13)
Press the folding lock button and then lift up the handlebar to open the folding lock.
Step on the lever, and then lift up the handlebar until the stroller is unfolded.
Make sure the pushchair has been opened correctly.
PARKING BRAKE (fig.14)
To apply the brake: Press the brake lever, push the pushchair forward gently to ensure the brake
has been applied correctly.
To release the brake: Lift the brake lever as shown.
ADJUSTING THE HANDLEBAR (fig.15)
Press both buttons "A" side handle and rotate the handle to the desired position.
FITTING THE BUMPER BAR (fig.16, fig.17, fig.18, fig.19, fig.20)
Assembly: Align the bumper bar and insert it in its seat on both sides, a click will indicate the
correct assembly.
Disassembly: Push the release button "A" on each side of the bumper bar and contemporary lift
the bar upwards to hook it off (fig.18).
Unhook the bumper bar on only one side : Push the release button "A" on one side of the bumper
bar and contemporary lift the bar upwards to open it as a gate.
Push the buttons "A" on both sides, to adjust the height of the bumper bar (fig.20).
INSTALL THE SEAT (fig.21, fig.22, fig.23, fig.24)
Align the seat with the adaptors and press until "click" sound.
Lift up the buttons of the adaptors with one finger at each side and lift up the seat to remove the
seat.
ADJUSTING THE CANOPY
Extend the hood according to requirements to protect baby from the sun.
Note: babies' skin is very delicate. NEVER leave baby under direct sunlight. Always make sure that
the hood has been adjusted correctly.
14
SuperTres