Safety Notes; Setting The Unit Into Operation - IMG STAGELINE BEAM-8/ WS Manual De Instrucciones

GB
Œ
Control elements and connections
Moving LED Beam Bar
Please read these operating instructions carefully
prior to operation and keep them for later reference.
1 Applications and Setup Options
The BEAM-8 / WS can be used to create effect illu-
mination, e. g. on stage, in discotheques or function
rooms. It features 8 powerful white 10 W LEDs,
mounted on a movable bar.
The light effect unit is designed for control via a
DMX light controller (14 or 5 DMX control chan-
nels), but it can also be operated on its own, run-
ning automatic or music-controlled light show pro-
grams.
The unit can be set up on an even surface. For
upside-down installation on a crossbar, two clamps
are provided: Insert each clamp in two holes located
on the bottom side of the unit and then turn the bolts
clockwise (to the stop) to securely lock the clamp.
2

Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains volt-
age. Leave servicing to skilled per-
sonnel only. Inexpert handling or
modification of the unit may result in
electric shock.
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range: 0 – 40 °C).
G
Do not operate the unit and immediately discon-
nect the mains plug from the mains socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
8
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the plug.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals. For cleaning the lenses, a
standard glass cleaner may be used.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
safely installed, if it is not correctly connected or
operated, or if it is not repaired in an expert way.
3

Setting the Unit into Operation

1) For power supply, connect the mains jack
POWER IN of the unit to a mains socket
(230 V~/ 50 Hz) using the mains cable provided.
Insert the blue POWERCON
cable into the mains jack, and then turn the plug
to the right until it engages. To remove the plug,
.
pull back the safety latch of the plug and turn the
plug to the left.
2) If multiple BEAM-8 / WS are used, the jack
POWER OUT of the first unit can be connected
to the mains jack POWER IN of the second unit.
For this, a mains cable with POWERCON
plugs (NAC-3FCB and NAC-3FCA) is required.
The second unit can then be connected to the
third unit, etc. until all units are connected in a
chain. Thus, up to 40 units can be connected
with each other.
The jack POWER OUT may also be used to
provide power to other (light effect) units. How-
ever, the current load of the jacks POWER IN
and POWER OUT must not exceed 20 A. Oth-
erwise, a short circuit and fire may occur due to
overload.
3) Use the POWER switch to switch on the light
effect unit. Various information will appear on
the display to indicate that the light effect unit is
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
® plug of the mains
®