Schulz AGE 250 Manual De Instrucciones página 55

2.1. RGG 25 Model:
• Make sure that the trimmer is fueled according to instructions in section 1 - Fuel (RGG25 model);
• Cold Start: Set the on/off switch 1 to "I" (Figure 8.1). Move the choke lever to the closed position (Figure
8.2 - Closed). Press starter pump bulb until fuel emerges and then press the bulb 6 times (Figure 8.3). Firmly
grasp the product and pull the starter handle 5 until the engine starts. Let the engine idle for 10 to 15 secon-
ds. Next open the choke and press the throttle lock 2 and throttle 3.
• Warm start: Set the on/off switch 1 to "I" (Figure 8.1). Move the choke lever to the open position (Figure
8.2 - Open). Firmly grasp the product and pull the starter handle 5 until the engine starts. Then press throttle
lock 2 and throttle 3.
• For warm or cold start, stopping the tool is the same: Release the throttle lock 2 and throttle 3 and let the
product run at idle for 10-15 seconds. Set on/off switch 1 in the "off" position.
FIGURE 8.1
2.2. Other models:
• Before connecting the product to the electric power network, check if the voltage coincides with the local
voltage. Connect the plug to the power supply;
• For models AGE 500 and RGE 1000: Pull safety button 4 forward and maintain throttle 3 pressed. To stop
the tool, release both.
• For models AGE 250 and AGE 350: Press and hold throttle 3. When the throttle is released, the tool will
automatically turn off.
ATTENTION:
been switched off. Wait until the head has come to a complete stop before placing the product on the ground.
CHOCKE LEVER POSITIONS:
The cutting accessories will continue to rotate for some time after the engine has
CLOSE
OPEN
FIGURE 8.2
55
FIGURE 8.3