Manual Flash Mode - Metz 50 AF-1 digital Manual De Instrucciones

TTL flash mode
This analogue flash mode is supported by older analogue cameras.
It is the normal TTL flash mode (TTL flash mode without preflash).
Setting procedure
TTL
TTL
F 8,0
4,3 50
m mm
Zoom
The normal TTL flash mode cannot be set on cameras supporting E-TTL or
E-TTL-II flash modes!
Some Powershot camera models support only the manual flash mode
M
„ " in the camera mode manual M!
TTL
In this case, „E " cannot be used.
Automatic TTL and E-TTL Fill-in flash mode
The automatic TTL or E-TTL fill-in flash mode is activated by most cameras when
the automatic programme P is selected and by Vari or subject programmes
during daylight (see camera operating manual).
Fill-in flash mode overcomes troublesome shadows and produces a more balan-
ced exposure between subject and background with contre-jour shots.
The camera's computer-controlled metering system sets the most suitable combi-
nation of shutter speed, aperture and flash output.
Ensure that the contre-jour light source does not shine directly into the
lens, as this will interfere with the camera's TTL metering system!
There is no setting or display for automatic TTL fill-in flash in the flash unit.
TTL
• Press „Mode" until „ " flashes in the
display.
The setting takes effect immediately.
After about 5 seconds the display stops
flashing and the setting is saved
automatically.
TTL
„ " appears in the display.

7.2 Manual flash mode

In the manual flash mode M , the flash unit emits the full uncontrolled amount of
light if no partial light output has been selected. The specific photographic situa-
tion can be taken into account by adjusting the aperture setting or by selecting a
suitable manual partial light setting. The setting area ranges from P 1/1 to
P 1/128 in M mode and P1/1 - P1/32 in M-HSS mode. The display shows the
distance at which the subject is correctly lit (see 5.2).
Setting procedure
M
• Press „Mode" until „ " flashes in the
display.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and
the setting is saved automatically. „
the display.
Manual partial light output levels
M
• In manual flash mode set the partial
light output desired with the buttons
+ and —. The setting takes effect immedia-
tely and is saved automatically.
The distance display is adjusted to the partial
light output automatically (see 5.2).
Various camera models support the manual flash mode
camera mode manual M! In other camera models an error message
appears in the display and the release is locked!
M M
6,1
m
Zoom
M
" appears in
M
M
P 1/4
3,0
m
Zoom
P1/4
M
only in the
F 5,6
50
mm
50
mm
89