Pre-Dialing - Daewoo DTD 7200 Manual De Instrucciones

registered handset will displays HS2 or HS3 on the LCD according to the registration sequence.
3) Press key to page the handset when difficult to look for.
OPERATION
Handset and hands-free mode
Press key once to obtain a dial tone, dial your number, when you hear the called party answers the
phone, you can begin your conversation.
During the conversation, press
Hands-free and handset volume control
During handset mode, press △ or ▽ key to adjust the handset volume. There are 5 levels for selection.
During hands-free mode, press △ or ▽ key to adjust the speaker volume. There are 6 levels for selection.
Mute the speakerphone
During a call, press
again to get back to the call and the MUTE will disappear.
Caller ID – type I & II
 TYPE I
After you have applied the caller ID service, you can see the caller party phone number during an incoming
ring.
TYPE II

During the conversation, the phone number of the incoming call of the third party can be seen in the unit.
This function can be worked when the user applied the Telecom service.
Flash
The flash function of R/CLR key can support some special network service, such as call waiting, call transfer,
etc. These services require a subscription and the operations depend on the different exchanger.
Pause
Press RD/P key will insert a time delay of 3.6 seconds in a dialing sequence.

Pre-dialing

The unit has pre-dialing function, when you may enter and edit the number before dial it out.
The following procedure describes how to use this function:
1. In idle mode, enter the number you want to dial. During entering, you can press R/CLR key to correct the
number.
2. Press key, the unit will dial out the number displayed on the LCD.
Redial function
1. Press key,
2. Press RD/P key, the last dialed number will be dialed again
NOTE: the maximum length of name & number are 12 characters & 20 digits respectively.
Intercom
The intercom feature is activated by pressing the INT key.
1. In idle mode, press INT key once.
2. The user will be prompted to select the number of the internal handset with which you wish to connect.
3. The destination handset will ring.
key to transfer the conversation mode between handset and hands-free.
key once to mute the mouthpiece and MUTE will show on LCD. Press
28
key