Maintenance And Inspection - Hitachi UR 18DSL2 Manual De Instrucciones

English
To turn the voice messages on/off
By factory default setting, the voice message function
plays "Welcome to Hitachi Power Tools" when the
power is turned on and "Presented by Hitachi Power
Tools" when the power is turned off .

MAINTENANCE AND INSPECTION

WARNING:
Inspecting the mounting screws
Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so could result in serious hazard.
Cleaning on the outside
When the radio is stained, wipe with a soft dry
cloth or a cloth moistened with soapy water.
Do not use chloric solvents, gasoline or paint thinner,
for they melt plastics.
Storing the Radio
Do not store the radio in the following places.
○ Within reach of or easily accessible to children
○ In humid or dusty places
○ In high temperature such as inside a car or
exposed to direct sunlight
○ In extremely cold places or directly exposed to
cold draughts
○ Where the temperature changes drastically
○ Where it is exposed to smoke or steam such as
near a cooking appliance or humidifi er
18
To mute the voice messages, press memory button
1 while the power is turned off and display [OFF] on
the display panel.
To restore the voice messages, press memory button
1 while the power is turned off and display [ON] on
the display panel.
When not in use or during inspection and maintenance, be sure
to remove the AC plug, rechargeable battery and backup batteries.
Service parts list
MODIFICATIONS:
Hitachi Power Tools are constantly being improved
and modifi ed to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without
prior notice.
CAUTION
Repair, modifi cation and inspection of Hitachi
Power Tools must be carried out by a Hitachi
Authorized Service Center.
This Parts List will be helpful if presented
with the tool to the Hitachi Authorized
Service Center when requesting repair or
other maintenance. In the operation and
maintenance of power tools, the safety
regulations and standards prescribed in each
country must be observed.