Assembly - Base - GLIDEAWAY ECOFLEX Comfort Base Manual De Instrucciones

ASSEMBLY - BASE

It is HIGHLY recommended to use two people for the installation of this product. To
assemble, please perform the following steps:
1
Carefully lift both Base Pieces from the
shipping carton, keeping the unit's top-
side down. Remove the plastic wrapping
from the bottom to access the bases.
2
Insert the Connecting Rods into one of the
Base Pieces and then slide the other Base
Piece onto the Connecting Rods as shown.
3
Secure the Base Pieces to each other using
the eight medium hex bolts (four hex bolts
for each Connecting Rod) making sure to
hand tighten each and then tighten 1/4
turn more, as over-tightening could cause
damage to the frame or Connecting Rod.
4
Insert the Legs into the threaded holes
at each corner of the base by inserting
the leg and rotating clockwise until tight.
There must not be any gap or wobble
in the Leg in order to avoid risk of injury
or damage to the base which may void
warranty.
5
Secure the Center Support to the
threaded holes in the middle of the bed
connecting both Base Pieces using the
four longer hex bolts making sure to hand
tighten each and then tighten 1/4 turn
more, as over-tightening could cause
damage to the frame.
See the diagram on the following page when
assembling one Base.
For steps 6 and 7, refer to igure a
on page 7.
6