Cleaning The Spray Gun Filter; Cleaning The Inlet Filter - WAGNER Paint Crew Plus Manual Del Usario

Spraying Troubleshooting -
The filter must be cleaned every time you use your sprayer. When using thicker spray materials, the filter might need to
be cleaned more often.
1. Perform Pressure Relief Procedure, page 7.
2. Unclip the trigger guard from the filter housing by pulling
outward from the filter housing. Unscrew the filter
housing.
3. Remove the filter from the spray gun housing and clean
with the appropriate cleaning solution (warm, soapy
water for latex paints, mineral spirits for oil-based
materials).
4. Inspect the filter for holes (see inset). Replace if holes
are found.
IMPORTAnT: nEVER POKE THE FILTER WITH A
SHARP InSTRuMEnT!
5. Replace the cleaned filter, tapered end first, into the
gun housing. The tapered end of the filter must be
loaded properly into the gun. Improper assembly
will result in a plugged tip or no flow from the gun.
6. Reassemble the spray gun.
Spraying Troubleshooting -
1. Perform Pressure Relief Procedure, page 7.
2. Empty the hopper of all spraying material (see
Emptying the Hopper, page 7). Clean any remaining
material residue inside the hopper with the appropriate
cleaning solution. The hopper must be completely dry.
3. Unscrew the hopper outlet (a). The valve stem, spring
and inlet filter will come out with the hopper outlet.
Remove the inlet filter from the hopper outlet, being
careful not to lose the spring or stem.
4. Clean the inlet filter using the appropriate cleaning
solution (warm, soapy water with latex paints, mineral
spirits with oil-based paints or stains).
5. Place inlet filter back over the valve stem and into
the hopper outlet. Thread hopper outlet back into the
bottom of the hopper.
6. Lubricate the hopper outlet o-rings with petroleum jelly.
If after having completed all of the steps on this
page you are still experiencing problems spraying,
refer to the Troubleshooting page (page 17).
English

Cleaning the Spray Gun Filter

Trigger Filter
guard

Cleaning the Inlet Filter

(a)
Inlet filter
Seal
Valve stem
Spring
Hopper outlet
O-rings
12
Tapered
end
(filter top)
Hole
Filter
housing