Dryer Use - KENMORE ELITE HE5 Manual De Uso Y Cuidado

11. When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close door. If you do not feel heat, turn off the dryer and
check that the gas supply line shutoff valve is open.
• If the gas supply line shutoff valve is closed, open it, then
repeat the 5-minute test as outlined above.
• If the gas supply line shutoff valve is open, contact a
qualified technician.
DRYER USE
p_: TME CYCLES
Tmtd Dly
I x(/r{ s_ Dly
< , _i!i;;!! ¸¸i¸ ii;!!
)))))
_/v DL/y i i _ I) y
/
Se_EN
[_}lJC! U_
OPT ONS
_ink e @ (i_rl 150
_im)/ BW 0
!_D ull * Iiyh: 0
_ )lp('lSt Jl_ D /'fleSS [ev;_
,<< t :
f
Cyc)e Sigr!al
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
fiammabme on it (even after washing).
Failure to re(low these instructions can result in death,
explosion, or fire.
Follow these basic steps to start your dryer. Please refer to
specific sections of this manual for more detailed information.
1. Clean lint screen before each load. See "Cleaning the Lint
Screen."
2. Place laundry in dryer and shut door.
3. Press the POWER button. Then rotate the dial or press a
Timed Cycles button to select the desired Auto or Timed
Cycle. The indicator light for the selected Auto or Timed cycle
will glow green. The preset modifiers for the selected cycle
will glow green. Selectable options will glow amber. If an
option or modifier is unavailable with the selected cycle, the
light will not illuminate. The estimated or actual cycle time (in
minutes) will show in the display.
Fire Hazard
No washer can completely remove o(I.
Do not dry anything that has ever had any type of oimon
it (including cooking oils).
(terns containing foam, rubber, or plastic must be dried
on a clothesline or by using an Air Cycle.
Failure to follow these instructions can resumt in death
or fire.
To use an Auto Cycle
NOTE: A light next to each feature will glow green when the
feature is selected.
• Select DRYNESS LEVEL to adjust how dry you want the
load. As the cycle runs, the control senses the dryness of
the load and adjusts the time automatically for the
selected dryness level.
NOTE: Most loads may be dried using Normal dryness
level, which is shown in bold letters on your control panel.
Normal is the energy preferred dryness level and will use
the least energy.
• Select the desired Options.
To make changes during an Auto Cycle:
• Select an Auto Cycle.
• Press STOP once.
• Adjust Dryness Level.
14