KENMORE ELITE HE5 Manual De Uso Y Cuidado página 13

Reverse the door handle
1. Place the outer door assembly face down on work space,
2. Remove the 6 screws that hold the intermediate door to the
outer door assembly, Remove the intermediate door, and set
hinge shield aside. Remove the hinge hole cover.
3=
A. Intermediate door
B. Hinge shield
C. Hinge hole cover
Rotate the window assembly 180° and reattach the
intermediate door, hinge shield and hinge hole cover with the
6 screws removed in Step 2.
Reinstalling the door
1. Place the inner door assembly into the outer door assembly,
To fit correctly, the inside door assembly edge is completely
inside the outside door assembly edge,
2. Reassemble the inner and outer door assemblies with the
5 screws.
3. Remove existing label from the opposite side of the door and
discard. Find label provided with the Use and Care Guide and
apply over original hinge holes.
NOTE: Two or more people may be needed to reattach the
dryer door.
A. Dryer door
B. Dryer front panel
C. Insert this hinge screw first,
5. Close the door and check that it latches securely.
6. Check for fingerprints on the glass, Clean the glass if
necessary.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Check the dryer's final location. Be sure the vent is not
crushed or kinked,
4. Check that the dryer is level. See "Level Dryer."
Electricam Shock Hazard
Pmug into a grounded 3 prong outmet,
Do not remove ground prong,
Do not use an adapter,
Do not use an extension cord,
Failure to foffow these instructions can result in death,
fire, or emectricaI shock,
4=
Align the door by placing the locating tabs on the hinge with
the locating holes on the dryer front panel. Insert and tighten
the center hinge screw. The door will hang in place while you
insert and tighten the remaining 4 screws.
5=
6.
7.
8.
9.
10.
Plug into a grounded 3 prong outlet. Turn on power.
Remove any protective film or tape remaining on the dryer.
Dispose of/recycle all packaging materials.
Read "Dryer Use."
Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust,
Select a Timed Dry heated cycle, and start the dryer. Do not
select the Air Only Temperature setting.
If the dryer will not start, check the following:
• Dryer is plugged into a grounded 3 prong outlet,
• Electrical supply is connected,
• Household fuse is intact and tight, or circuit breaker has
not tripped.
• Dryer door is closed,
13