DeWalt DW735 Manual De Instrucciones página 8

DAMAGE TOTHEHEIGHT ADJUSTMENT SYSTEM O NYOUR
PLANER WILL RESULT.
PLANING BASICS
Proper Planing Technique
TO PLANE YOUR MATERIAL
1. Lower the carriage to the desired height for your first pass.
2. Turn the unit on and feed the material into the feed rollers.
3. Examine the finished cut and adjust the carriage to the
appropriate height for your next pass.
NOTE: Flip the board back and forth between each pass as
recommended in Proper Planing Techniques.
See the Troubleshooting Guide, page 14, for additional information.
_WARNING: DO NOT TURN THE UNIT ON WITH THE MATERIAL
ALREADY INSERTED UNDER THE CARRIAGE. WAIT UNTIL THE
ROLLERS AND CUTTER HEAD ARE UP TO FULL SPEED BEFORE
FEEDING YOUR MATERIAL INTO THE MACHINE.
For best results, plane both sides of the workpiece to reach a
desired thickness. For example, if you need to remove 1/8" from
your workpiece, remove 1/16" from each side. This not only allows
the workpiece to dry with a even moisture content, it also produces
finer cuts.
A WARNING: Plane only wood that is free from foreign objects, with
no loose knots and as few tight knots as possible. Do not plane wood
that is severely warped, twisted, knotted or bowed.
_ WARNING: Do not place your body between the rear of the planer
and a stationary object while material is feeding. Serious injury could
result.
MINIMUM/MAXIMUM WIDTH/HEIGHT/DEPTH
NOTE: Always plane in the direction of the grain. Support the
workpiece adequately at all times. Planing material less than 3/4"
wide is not recommended. If you must
plane narrow material, group several
pieces together and plane them as one
wide workpiece whenever possible.
The maximum depth of cut your planer
can take in one pass is 1/8" (on material
less than 6" wide). Never attempt to
modify your planer to take a deeper cut.
Follow the recommended depth/width of
cut guidelines shown in Table A for best
results.
Snipe
TABLE A
/ y, MMERIAL r_ _
_ i I REMOVAL i
i f_-I GAUGE _ J
_ C3DEPT j
__ °FcuT i
3" 6" 9" 13" _-
Snipe is a depression made when an unsupported end of your
material drops toward the floor, causing the opposite end to lift up
into the cutter head.
TO AVOID SNIPE
Feed the workpiece into the planer so it is level and remains flat
against the base at all times.
Keep the workpiece level throughout planing operation by receiving
or "catching" it from the rear of the planer.
If you are planing material that is especially long, the use of
additional material support is recommended.
Twisted, Cupped and Bowed Wood
If both sides of your material are very rough or if the material is
cupped, bowed or twisted, your planer may not produce the desired
result. Ideally, you should have at least one level face/surface on
your material before you plane. Your thickness planer will work best
with material that has been run through a jointer to produce one flat
surface. If you do not have at least one flat surface or a jointer, see
the following recommendations.