Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Knob
Base
2.
Adjusting the angle of inclination
WARNING:
If the lever (A) and wing bolt are loose, injury can
result. Tighten it securely after adjustment.
You can incline saw blade from 0˚ to a maximun
angle of 45˚ in relation to the base.
As shown in Fig. 4, 5 by loosing the lever (A) on
the bevel scale and the wing bolt on the base, the
saw blade may be inclined to an angle of 45˚ in
relation to the base.
Always ensure that the lever (A) and wing bolt are
thoroughly tightened after making the desired
adjustment.
Lever (A)
Wing-bolt
Base
Handle
Fig. 3
Base
Fig. 4
Fig. 5
3.
Regulating the guide (Rip fence) (Fig. 6)
After loosen clamp lever, insert the guide into the
base, move it left and right and adjust the cutting
position. Tighten the clamp lever and fix the guide.
The guide can be installed either from the left or
the right side of the main body.
Clamp lever
4.
Fine tuning of parallelism
It is possible to fine-tune the parallelism of the saw
blade to the base using the parallelism adjustment
screw.
Adjustment has already been made at the time of
shipment from the factory. However, in the unlikely
event of parallelism being faulty, adjust as follows.
(1) Unfasten only the mounting screws of the
saw cover hinge portion (Fig. 7).
Mounting screw
Saw cover hinge
(2) Retract the lower guard into the blade cover.
(3) Insert wood chip in the rear side of the saw
blade base, and mark the position on the base
(Fig. 8).
Wood chip
Fig. 8
English
Guide
(Rip fence)
Fig. 6
Fig. 7
Blade cover
Lower guard
9
Tabla de contenido
