Tabla de contenido
Idiomas disponibles
Idiomas disponibles
● Should the saw blade be stopped or make an
abnormal noise during operation, turn off the
switch immediately.
● Don't remove circular saw from work piece during
a cut while the saw blade is moving.
● Support large panels to minimize the risk of blade
pinching and KICKBACK. Large panels tend to sag
under their own weight. Supports must be placed
under the panel on both sides, near the line of cut
and near the edge of the panel as shown in Fig. 14.
To minimize the risk of blade pinching and
kickback. When cutting operation requires the
resting of the saw on the work piece, the saw shall
be rested on the larger portion and the smaller
piece cut off.
To avoid kickback, do support board
or panel near the cut.
Fig. 14
Don't support board or panel away
from the cut.
Fig. 15
● Place the wider portion of the saw base on that
part of the work piece which is solidly supported,
not on the section that will fall off when the cut is
made. As examples, Fig. 16 illustrates the RIGHT
way to cut off the end of board, and Fig. 17 the
WRONG way. If the work piece is short or small,
clamp it down.
DON'T TRY TO HOLD SHORT PLACES BY HAND!
● Wear eye protection.
● Avoid cutting any material like metal, etc., that
give off sparks.
CAUTION:
● Always take care in preventing the power cord
from coming near the revolving saw blade.
● Before starting to saw, ensure that the saw blade
has reached full speed revolution.
1.
Place the saw body (base) on the work piece, and as
in Fig. 18 align the intended line of cut with the saw
blade, using the notch of guide piece on the front of
the base. This relationship of base to work pieces
should remain unchanged regardless of the
inclination of the base.
When
Inclined 45°
English
Fig. 16
Fig. 17
When not
Inclined
Fig. 18
11
Tabla de contenido
