Panasonic PT-LB20NTU Instrucciones De Operación página 49

CONTROL KEY
To disable the buttons on the
projector, set "CONTROL KEY" to
"OFF". A confirmation screen will
then be displayed. Select "OK" by
using I or H button. To use the
buttons on the projector, set to "ON"
by using the remote control unit.
AUTO POW.OFF
If no signal is input to the projector
for the duration of the period you
set, the projector will return to
standby mode. The period can be
set from 15 minutes to 60 minutes
in 5 minute intervals. If you don't
use this feature, set it to "DISABLE".
This feature will not function when
using the "FREEZE" function.
POWER MEMORY
This sets the projector's start up
status for when the power cord is
connected.
ON
The projector will start from the
same status as when the power
cord was disconnected. If the power
cord was disconnected during
projection when the projector was
used the last time, projection will
start after the power cord is
connected.
OFF
The projector will be in standby
mode.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
48-E
NGLISH