Before Recording; Recording - Teac CD-RW890MKII Manual Del Usuario

Before Recording

Before you start recording, make sure that you understand
the following points:
< Up to 99 tracks can be recorded according to the CD standards .
When a 100th track is about to be recorded, recording will stop
automatically .
< A track less than 10 seconds in length on an audio CD cannot be
recorded .
< If the Stop (H) button or Pause (J) button is pressed within 10
seconds from the beginning of a track, the unit continues to
record no signal and stops when the track's length reaches 10 seconds .
< When recording is finished, "PMA WRITE" blinks for a few seconds,
and then the unit goes into the stop mode . Do not apply shock or
vibration to the unit while recording or "PMA WRITE" blinks .
< When the available recording time reaches 0, recording will stop
automatically .
< If a half-way recorded disc is inserted, recording continues next to
the last recorded track .
< You can add tracks to an unfinalized recordable disc . Once
finalized, a CD-R disc is "fixed" and behaves in the same way as a
CD . Finalized CD-RW discs, however, can be unfinalized, erased and
re-recorded .
< When the auto track function is used, the tracks are separated
based on the specified level . Therefore, if a silent part is contained
at the beginning or in the middle of a track, the playback time may
not be the same as the actual length of the track .
< When track numbers are added to continuous music such as live
performances, the sound is cut a moment .
< If a disc recorded with this unit is played with another player,
noises may occur when the track changes .

Recording (1)

1
Load a recordable CD-R or CD-RW disc into the unit.
Press the OPEN/CLOSE (L) button, place a disc on the disc tray
with the disc label side up, and then press the OPEN/CLOSE (L)
button to close the disc tray .
Make sure "NO TOC" and "CD-R" (or "CD-RW") indicator lights on
the display .
2
Select the source to be recorded using the INPUT SELECT
button.
Each time the INPUT SELECT button is pressed, the display changes
as follows:
DIGITAL (OPTICAL IN)
Select this to record a source connected to the DIGITAL IN terminal .
ANALOG (ANALOG IN)
Select this to record a source connected to the ANALOG IN
terminal .
< The input source cannot be changed during recording .
3
Select the mode of track number assignment using the
AUTO/MANUAL button.
When the AUTO/MANUAL button is pressed once, the current
increment level is displayed . Press the AUTO/MANUAL button
repeatedly to select another setting .
S-LVL -60 S-LVL -50
MANUAL
* Appears only when using ANALOG input
< After 2 seconds have passed, the display returns to the track/time
display .
S-LVL -40 S-LVL -30
A-TIME xx*
Continue to the next page
17