John Bean B 1200P Manual De Operador página 88

3
88
4-12
4
4-11
4-12
Operation "MANUAL MODE"
5.10.3.1 Saving a Wheel Profi le
Up to 9 wheel profi les can be saved.
— Clamp the wheel you wish to save the profi le of.
— Set and acquire all the wheel data including
the number of spokes if an Alu P is required.
— In the RIM DATA ENTRY screen select the
"SPECIAL" key (Fig. 4-12).
The WHEEL PROFILES screen (Fig. 4-11) will open.
The current wheel profi le data is highlighted in a line
on its own at the bottom of the page.
— In the 9 position list, use the Scroll command
to choose the current profi le registration position.
— Press the (3, Fig. 4-11) key to save data.
The data is now saved permanently in the chosen
position and can be recalled when required.
Note:
If the profi le is overwritten with other data it is no longer
shown in the list.
5.10.3.2 Recalling a Wheel Profi le from the memory
— Clamp the wheel to the balancer.
— In the RIM DATA ENTRY screen select the
"SPECIAL" key (Fig. 4-12).
The WHEEL PROFILES screen (Fig. 4-11) will open.
— Type on one of the nine lines to select the
profi le indicated for the wheel on the machine.
— Press the (4, Fig. 4-11) key to apply the
selection.
The ENTERING RIM DATA screen (Fig. 4-12) will open
and show the data recalled.
— Check that the settings in the Indications Field
and Status Bar panel are correct.
The machine is now ready to proceed with the
F
measuring run ( 5.8).