Correct Usage - Toshiba MMU-AP0091H Manual Del Propietário

CORRECT USAGE

When you use the air conditioner for the first time or when you change the SET DATA value, follow the proce-
dure below. From the next time, the operation displayed on the remote controller will start by pushing the
button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
*
but it is not a failure.
• While using the air conditioner, operate it only with
power switch and the leak breaker.
• Do not turn off the leak breaker while the air conditioner is used.
• Turn on the leak breaker 12 hours or more before start of operation after the air conditioner has stopped
for a long time.
3
1
Push button.
The operation lamp goes on, and the operation starts.
2
Select an operation mode with the
One push of the button, and the display
changes in the order shown on the right.
• "DRY" function is not provided to
Concealed Duct High Static Pressure Type.
3
Select air volume with
One push of the button, and the display changes in the order shown on the right.
• When air volume is "AUTO
set temperature and room temperature.
• In DRY mode, "AUTO
• In heating operation, if the room temperature is not heated sufficiently with volume "LOW
select "MED. " or "HIGH
• The temperature which the temperature sensor detects is one near the air inlet of the indoor unit.
Therefore it slightly differs from the room temperature according to the installation status. The setup
value is a criterion of the room temperature. (Automatic air speed cannot be selected in FAN mode.)
• Air volume of function is not provided to "Concealed Duct High Static Pressure Type" but air speed
"HIGH " only is displayed.
4
Determine the set up temperature by pushing the "TEMP.
Stop
Push button.
The operation lamp goes off, and the operation stops.
REQUIREMENT
UNIT
SET CL
button.
button.
", air volume differs according to the temperature difference between
" is displayed and the air volume is LOW.
" operation.
8
button without turning off the main
1
2
4
AUTO HEAT DRY
(Dehumidity)
AUTO HIGH
" or "TEMP.
COOL FAN
MED. LOW
" operation,
" button.