Installation; Tools And Materials; Initial Conditions And Checks; Environmental Conditions - Erreka TORO Manual Del Instalador

INSTALLATION

1

TOOLS AND MATERIALS

Set of screwdrivers
Fixed wrenches of 10 mm and 17 mm
Allen keys of 2.5 mm, 3 mm and 6 mm.
Marker pencil
2

INITIAL CONDITIONS AND CHECKS

Initial conditions of the gate

Check that the size of the gate is within the
admissible range of the operator (see the
technical features of the operator).
 If the gate to be automated has a personnel
door, use a safety device to prevent the
operator from running with the personnel door
open.

We recommend installing opening and closing
stoppers in order to prevent inertia from taking the
gate beyond the limit switches.

Environmental conditions


This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the power supply installation fulfils the
following requirements:
• The nominal voltage of the installation must
coincide with that of the control panel.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.
Spirit level
Tape measure
Underground electrical cable ducts

The gate must be easy to handle manually, namely:
• It must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its open/
close.

Do not install the operator in a gate which does
not work correctly in manual operation, as this
may lead to accidents. Repair the gate before
installing.

Check that the admissible environmental
temperature range for the operator is suitable
for the location.
English
TORO operator for sliding gates
61