Tabla de contenido
60
A
5-24
5-24a
5-24b
Operation
5.9.2 Application with gauge arm
Weight will be positioned to the left compared to the
contact point (A) of Gauge on rim (Figure 5-24).
Refer to (Figure 5-24a).
The gauge arm must be used to apply the stick-on
weights.
• Turn the wheel until it reaches the balancing
position of the right plane.
• Press break pedal to lock the wheel in this
position.
Decide now whether to use the Split Weight Mode
F
SWM (
5.11.1).
• Clean the fi tting position before attaching the
stick-on weights.
• Insert at the centre of the arm gauge a stick-on
weight that complies with the unbalance detected
and remove the adhesive protective strip (Figure
5-24b).
Note: When the measuring arm has been removed
and the correct position has been reached, the
unit emits an acoustic signal.
• Apply the weight to the correct point of the rim.
• Rotate the wheel to the next WAP position, put the
stick-on weight on the arm and apply the weight at
the left plane reference point.
• At the end perform a measuring run.
Tabla de contenido
