Operation - cecotec CONGA 1490 Manual De Instrucciones

ENGLISH

4. OPERATION

Touch display
Fig. 9
On/off button
Wi-Fi indicator light
Battery indicator light
Note: The power button on the robot and on the remote control has the same function.
On/off button
Press the On/off button to start the robot up.
From the Standby mode:
Press the On/off button to start Auto cleaning mode.
Hold down the On/off button for 3-7 seconds to enter network configuration.
Hold down the On/off button for 7 seconds to enter standby mode.
During operation:
Press the On/off button to stop operation.
During charging:
Press the On/off button to start Auto cleaning mode.
Wi-Fi indicator light
When entering network configuration (see before section), the white light will blink slowly.
When the device connects to the Wi-Fi, the white light will turn steady.
If the device fails to connect, the white light will blink faster.
Battery indicator light
The light will turn red when the battery is low.
The light will switch from blue to red alternately during charging.
The light will turn steady blue when it is totally charged.
Battery charging
Charging base
Place the charging base against the wall.
Remove any obstacle from around the charging base, following the safety distances shown
on the below picture:
Always turn the robot's power switch ON before placing it on the charging base.
Fig. 10
Power connection
Plug one of the adapter ends into the robot's charging socket and the other to the power supply.
While the charging base is connected to the power supply, press the Home button on the
38