Connection, Control And Display Elements - Cameo SCUBA Manual De Usuario

CONNECTIONS, CONTROL AND DISPLAY ELEMENTS
2
1
1
POWER IN
IEC power socket with integrated fuse holder. A suitable IEC power cable is included in delivery.
IMPORTANT INFO: Replace the fuse only with a fuse of the same type and values. If a fuse trips repeatedly, please contact an authorized
service center.
2 POWER OUT
IEC power out socket. Serves to provide power to additional CAMEO spotlights (maximum total connected value of 5A).
3
DMX IN
Male 3-pin XLR connector to connect a DMX control device (e.g. DMX console).
4
DMX OUT
Female 3-pin XLR connector to transmit the DMX control signal.
5
SAFETY EYEBOLT
When installing on a crossbeam, secure the device using a suitable safety cable on the safety eyebolt.
6 FANS / VENTILATION GRILLES
In order to avoid overheating the device, ensure that the ventilation grille is not covered and that air can circulate freely.
7
IR SENSOR
Infrared sensor to control via IR remote control (included in delivery).
8
LENS
Adjustable glass lens. To focus the projection at different distances, loosen the retaining screw in the thread ring,
grip the lens in the knurled socket, and screw it in or out of the housing (turning clockwise = distant range, turning counterclockwise = close
range). Secure the lens after focusing using the retaining screw in the thread ring. Make sure that the lens is screwed into the threaded ring of
the housing with at least one full rotation.
9
10
5
6
3
4
7
8
5