Replacing A Fuse; Lifting The Machine; Mowing Deck - Sharpening And Replacing The Blades; Sharpening The Blades - EMAK Oleo-Mac OM 92 Manual De Uso

Replace the fuel filter according to the instructions contained in the user's manual for the
engine supplied by its manufacturer.
6.3.3 REPLACING LIGHT BULBS
Light bulbs are seated in a bayonet catch and are accessible after lifting the hood.
Type of light bulb used:
Halogen light bulb MR16 12V / 20W GU5.3
When replacing the halogen light bulbs first press the tab (1) and slide the bulb out of
the socket (2). For installation proceed in the reverse sequence.
When replacing a light bulb, always use the same type of light bulb or an equivalent
recommended by the light bulb vendor!

6.3.4 REPLACING A FUSE

If a fuse is damaged the engine will immediately shut off, the mowing deck will stop and all indicator
lights on the dash board will turn off. In this case it is necessary to find the faulty fuse and replace it
with a new one. Under no circumstances should you replace a faulty fuse with a fuse that has a higher
current rating!
Fuses are located on the steering column and are accessible after lifting the hood and removing the
protective fuse cover.
Remove the fuse and insert a new fuse with the same rating as the initial fuse, i.e. 15A or 5A. If even
after replacing the fuse the engine or the mowing deck will not work, contact an authorised service
centre.
Certain machine models are equipped with a central switchboard. Under no condition should you
tamper with the switchboard! The only exception is the replacement of fuses.

6.3.5 LIFTING THE MACHINE

If you wish to lift the riding mower, use a jack and supports.
Proceed as follows:
Place the jack underneath the transmission on the rear axle and lift the rear part of the machine.
Insert two supports underneath the ends of the axles from the inner side of the rear wheels.
Lift the front part of the machine and insert two supports under both ends of the front wheel axles.
Never lean the machine to the side where the carburettor is located. Oil could enter the air
filter!

6.3.6 MOWING DECK - SHARPENING AND REPLACING THE BLADES

SHARPENING THE BLADES

The mowing blades must be sharp, statically balanced and straight. Blunt, incorrectly sharpened or
damaged mowing blades cause grass to be torn out of the ground, damage to lawns and mediocre
collection of mowed grass in the grass catcher.
- Do not repair a blade that is deformed or otherwise damaged, replace it immediately.
- Whenever handling the mowing blades, always use heavy-duty work gloves.
51
6.3.3a