Tabla de contenido
2
Notes on safety
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall
outlet before opening the face plate of the control box. Touching areas where high voltages are present can
result in severe injury.
Use the sewing machine in an area which is free
from sources of strong electrical noise such as
high-frequency welders.
Sources of strong electrical noise may cause
problems with correct operation.
Any fluctuations in the power supply voltage
should be within ±10% of the rated voltage for
the machine.
Voltage fluctuations which are greater than this
may cause problems with correct operation.
The power supply capacity should be greater
than the requirements for the sewing machine's
electrical consumption.
Insufficient power supply capacity may cause
problems with correct operation.
The ambient temperature should be within the
range of 5°C to 35°C during use.
Temperatures which are lower or higher than
this may cause problems with correct operation.
Machine installation should only be carried out
by a qualified technician.
Contact your Brother dealer or a qualified elec-
trician for any electrical work that may need to
be done.
The sewing machine weighs more than 37 kg.
The installation should be carried out by two or
more people.
Do not connect the power cord until installation
is complete, othewise the machine may oper-
ate if the treadle is pressed by mistake, which
could result in injury.
Be sure to connect the ground. If the ground
connection is not secure, you run a high risk of
receiving a serious electric shock, and problems
with correct operation may also occur.
CAUTION
Environmental requirements
Installation
LZ2-B855E,B856E (English)
DANGER
The relative humidity should be within the
range of 45% to 85% during use, and no dew
formation should occur in any devices.
Excessively dry or humid environments and
dew formation may cause problems with cor-
rect operation.
Avoid exposure to direct sunlight during use.
Exposure to direct sunlight may cause prob-
lems with correct operation.
In the event of an electrical storm, turn off the
power and disconnect the power cord from the
wall outlet.
Lightning may cause problems with correct op-
eration.
All cords should be secured at least 25 mm away
from any moving parts. Furthermore, do not
excessively bend the cords or secure them too
firmly with staples, otherwise there is the dan-
ger that fire or electric shocks could occur.
install the belt covers to the machine head and
motor.
If using a work table which has casters, the cast-
ers should be secured in such a way so that they
cannot move.
Be sure to wear protective goggles and gloves
when handling the lubricating oil, so that no oil
gets into your eyes or onto your skin, otherwise
inflammation can result.
Furthermore, do not drink the oil under any cir-
cumstances, as it can cause vomiting and diar-
rhea.
Keep the oil out of the reach of children.
ii
Tabla de contenido
