Troubleshooting Guide - Dirt Devil Ud70095 Manual Del Propietário

TROUBLESHOOTING GUIDE

WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
PROBLEM POSSIBLE REASON
Cleaner won't run
1. Not properly plugged into wall
outlet.
2. No electricity in wall outlet.
3. On/off pedal not turned on.
4. Motor thermostat tripped.
5. Blown fuse.
Cleaner won't 1. Full or clogged dirt container.
pick up
2. Clogged nozzle.
3. Clogged dirt inlet.
4. Clogged hose.
5. Hose not inserted fully.
6. Dirty filters or filter container.
Accessories won't 1. Accessories not attached
pick up correctly.
Brushroll does not 1. Brushroll blocked.
turn
2. Belt broken.
3. Brushroll will not spin by hand.
Air flow restricted 1. Attachment use restricts air flow.
with attachment
use 2. Airpath/hose clogged.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
our website at www.dirtdevil.com. Costs of any transportation to and from any place of repair are to be paid by the
owner. The service parts used in this unit are easily replaced and readily available from an authorized Royal
or retailer. Always identify your cleaner by the model number and manufacturing code when requesting information or
ordering replacement parts. (The model number appears on the bottom of the cleaner.)
POSSIBLE SOLUTION
1. Plug in firmly.
2. Check fuse or breaker.
3. Push on/off switch to on.
4. Switch off and unplug the vacuum cleaner.
Leave for 30 min.
5. Contact customer service.
1. Clean dirt container.
2. Remove obstruction.
3. Unplug cleaner, Remove nozzle guard cover
and remove obstruction.
4. Remove obstruction.
5. Push hose in securely.
6. Clean/change filters or filter container.
1. Refer to page 5 for fitting information.
1. Remove blockages.
2. Replace belt.
3. Contact customer service.
1. Check attachment.
2. Remove obstruction.
® Dealer or visit
11
Dealer
®