Cleaning The Evaporator; Cleaning The Condenser - Polar DN492 Manual De Instrucciones

Cleaning the evaporator

• Clean the evaporator periodically.
• As the fins of the evaporator are very sharp. Always wear protective gloves.
• Only a brush can be used for cleaning. Do not use jets of liquid or sharp instruments.
• To access the evaporator proceed as follows:
1. Open the door (A) of the appliance.
2. Loosen the two screws (B) on the right of the deflector.
3. Remove the runner (C).
4. Turn the deflector (D) to the left.
1
B

Cleaning the condenser

• Clean the condenser periodically.
• As the fins of the condenser are very sharp, always wear protective gloves.
• Use protective masks and glasses in the presence of dust.
• Whenever the condenser has a deposit of dust in correspondence with the fins, this can be removed
using a suction device or with a brush applied, using a vertical movement along the direction of the
fins.
• No other instruments must be used, which may deform the fins and therefore the efficiency of the
appliance.
• To clean, proceed as follows:
1. Open the door (A) of the appliances.
2. Remove the lower panel (B). To do this, remove the screw fasteners (C).
3. It is now possible to clean the finned part of the condenser (D) using suitable tools and protection
devices.
4. After cleaning, close the control panel and fix it with the screws removed beforehand.
2
DN492-DN493-DN494 _ML_A5_v5_20200908.indb 7 DN492-DN493-DN494 _ML_A5_v5_20200908.indb 7
C
B
A
B
A
D
D
C C
UK
7
2020/9/8 14:03 2020/9/8 14:03