Polar DN492 Manual De Instrucciones página 4

UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects
for ventilation. Increase this distance if the
obstacle is a heat source. Do not block front
ventilation grills.
Note: Before using the appliance
for the first time, clean the
interior with soapy water.
3. Set the brakes on the castors to keep the
appliance in position.
Operation
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
• It is important that food entering the Blast
Chiller/Freezer does not exceed a temperature
of 90°C.
• It is recommended that metal containers /
trays are used as other materials such as
plastic or polystyrene containers will act as an
insulator and extend blast chilling times.
• Sufficient space must be left between products
in order to guarantee a sufficient flow of cold
air. Ensure product is not in contact with the
internal walls of the unit, and leave sufficient
gaps between trays.
• Never obstruct the inlet of the evaporator fans.
• Products that are more difficult to chill because
of their composition and size should be placed
in the centre of the unit.
4
DN492-DN493-DN494 _ML_A5_v5_20200908.indb 4 DN492-DN493-DN494 _ML_A5_v5_20200908.indb 4
• Blast chilling data refers to standard products
(low fat content) with a thickness below
50 mm: therefore avoid overlaying products
on trays or the insertion of pieces with a
much higher thickness, as this will lead to
an extension of blast chilling times. Always
distribute the product well on the trays and in
the case of thick pieces decrease the amount
to blast chill.
• Limit the number of times and the duration of
time the doors are opened.
• The chiller should be used for storage for short
periods only.
• When removing product that has undergone
blast chilling/shock freezing, always wear
gloves to protect the hands from cold burns.
Control Panel
Turn On
To switch the appliance on, press
will place the unit in standby whilst waiting for the
cycle to be selected.
Insert the food probe
• Before selecting which cycle to use, the probe
must be inserted into the food. This allows
the internal temperature of the food to be
measured.
• It is important that the probe is correctly
connected to the unit, or an alarm will activate
and the appliance will not function.
Note: To prevent bacterial
contamination or contamination
of any other biological nature,
the needle probe must be
disinfected after use.
button. This
2020/9/8 14:03 2020/9/8 14:03