LEGRAND 430 521 Manual De Usuario página 26

INSTALLATION WITH SURFACE MOUNT BRACKET
a Remove the ceiling tile from the ceiling and cut a
hole whose diameter is 30~40mm on the ceiling
tile to pass the wires and cables through to the
upside of the ceiling. (In case of wiring and
cabling through the ceiling tile only)
c Connect the wires and cables to the ports and
install the main body. (Machine M3x8).
Important Notice
• Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
• When the pipe hole for wiring and cabling on side of the Surface Mount Bracket is not used, make sure that the
hole is properly sealed with the supplied Hole Plug.
b Prepare the surface mount bracket.
Pull the wires and cables for the system as
!
below. Attach the surface mount bracket to the
!
!
mounting surface.
(Tapping M4x25)
d Align the dome cover stud with the dome cover
assembly stud and slightly push the dome cover
to the ceiling. Turn the dome cover clockwise and
screw on the dome cover lock-up screw.
Then remove the protection vinyl from the dome
cover. (Machine M3x6).
26