Hitachi Koki CS 40EA Manual De Instrucciones página 18

English
For long-term storage
Drain all fuel from the fuel tank. Start and let engine
run until it stops. Repair any damage which has
resulted from use. Clean the unit with a clean rag,
or the use of high pressure air hose. Put a few drops
of two-cycle engine oil into the cylinder through the
spark plug hole, and spin the engine over several
times to distribute oil.
Cover the unit and store it in a dry area.
Chain sharpening
Parts of a cutter (Fig. 46, 47)
50
51
52
53
54 55
59
WARNING
○ Gloves should be used when sharpening chain.
○ Be sure to round off the front edge to reduce the
chance of kickback or tie-strap breakage.
50. Top plate
18
49
Fig. 45
58
57
56
Fig. 46
60
61
62
Fig. 47
51. Cutting corner
52. Side plate
53. Gullet
54. Heel
55. Chassis
56. Rivet hole
57. Toe
58. Depth gauge
59. Correct angle on top plate (degree of angle
depends on chain type)
60. Slightly protruding "hook" or point (curve on
non-chisel chain)
61. Top of depth gauge at correct height below top
plate
62. Front of depth gauge rounded off
Lowering depth gauges with a fi le
1) If you sharpen your cutters with a fi le holder,
check and lower the depth.
2) Check depth gauges every third sharpening.
3) Place depth gauge tool on cutter. If depth gauge
projects, fi le it level with the top of the tool.
Always fi le from the inside of the chain toward an
outside cutter. (Fig. 48)
4) Round off front corner to maintain original shape
of depth gauge after using depth gauge tool.
Always follow the recommended depth gauge
setting found in the maintenance or operator
manual for your saw. (Fig. 49)
Fig. 48
Fig. 49