DWE
120V / 650W
120V / 650W
N L
E
230V
The connection cable must have a diameter of at least 3 x 1,5 mm !
Installing/Replacing the lamps
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 20 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need 4 - 8 DWE 120V/650W PAR-36 WFL lamps.
During the operation, the lamp reaches temperatures of up to 640° C.
Procedure:
Step 1: Unscrew the lamp cover.
Step 2: If replacing the lamp, remove the old lamp from the housing and loosen the screws and wires.
Step 3: Loosen the screws on the new DWE 120V/650W PAR-36 WFL lamp with an appropriate
screwdriver.
Step 4: Connect the wires with the lamp using an appropriate screwdriver.
Step 5: Tighten the screws.
Step 6: Insert the lamp in the housing.
Step 7: Screw the lamp cover back on.
Audience Blinder, 4/8 x PAR-36
Connection possibilities
230V voltage
DWE
DWE
DWE
120V / 650W
120V / 650W
N L
N L
N L
E
230V
DANGER TO LIFE!
Only install the lamps with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
DWE
DWE
120V / 650W
120V / 650W
N L
N L
E
230V
CAUTION!
14/31
DWE
DWE
120V / 650W
120V / 650W
N L
N L
E
230V
2
42103420_V_1_0_3046.DOC