Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the projector. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be
used. The projector must never be fixed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Use 2 appropriate clamps to rig the fixture on the truss.
Follow the instructions mentioned at the bottom of the base.
Make sure that the device is fixed properly! Ensure that
the structure (truss) to which you are attaching the fixtures is secure.
DANGER OF FIRE!
CAUTION!
24/58
The
Moving-Head
can
directly on the stage floor or rigged in
any orientation on a truss without
altering its operation characteristics
(see the drawing).
For overhead use, always install a
safety-rope that can hold at least 12
times the weight of the fixture. You
must only use safety-ropes with screw-
on carabines. Pull the safety-rope
through the hole on the bottom of the
base and over the trussing system etc.
Insert the end in the carabine and
tighten the fixation screw.
Use the safety-rope exclusively as a
closed ring. Never use by only securing
at each end. The maximum drop
distance must never exceed 20 cm.
A safety rope which already hold the
strain of a crash or which is defective
must not be used again.
51786400X51NXS_V_1_0.DOC
be
placed
Tabla de contenido
