Hardware Installation; Software Installation - Akasa integral Manual De Usuario

for Mac
5.
Gently insert the tray into the enclosure
aligning the guide rail with the grooves of the
enclosure housing.
7.
Insert the tray completely into the housing
and secure the tray face plate to the
enclosure using the screws provided.
16
Harddisk Installation
6.
Before fully inserting the tray, connect the
HDD activity LED to the -pin connector.
Make sure the blue wire is to the outside and
the red wire is to the inside.
NOTE: The integral logo on the front bezel
serves two operational purposes: indicates
power and hard drive activity.
-pin HDD activity
LED connector
8.
Connect the round end of the DC power cord
to the back of the enclosure, making sure it is
correctly aligned. Plug the AC cable into the
power pack, and then connect the supplied
adapter into an available AC socket.
NOTE: please ensure you are using the
supplied power pack only.
for Mac
USB Mode Connection

Hardware installation

1. Connect your INTEGRAL LAN to the computer using the supplied USB cable
2. Switch on the power and your INTEGRAL LAN is ready to use.
CAUTION! Do not connect USB cable
and Ethernet cable at the same time.

Software installation

Mac OS 8.6
If you are using Mac OS 8.6, the software of Mass Storage Support 1..5 is required for
installation. You can download The USB Mass Storage Support 1..5 from the Apple Software
Updates web site Http://www.apple.com/support .
Mac OS9.0 or later
You don't need to install this software if you have installed Mac OS 9.0 or above.
When you connect the INTEGRAL LAN into the USB port of the Mac computer, the mass storage
volume should appear on the desktop in a few seconds automatically.
Using the INTEGRAL LAN Device
After the first installation, you can connect or disconnect the INTEGRAL LAN device without powering
off the computer, please follow the steps when you want to do the above actions
Connecting the INTEGRAL LAN device
1. Connect one end (type B) of the USB cable into the USB port of your INTEGRAL LAN enclosure.
2. Connect the other end of the USB cable (type A) into any active USB port of the computer.
. Plug the AC power cord to the INLET of your INTEGRAL LAN enclosure and turn on the power
switch. Your INTEGRAL LAN device is ready to use.
Disconnect the INTEGRAL LAN Device
When disconnecting your INTEGRAL LAN drive from
the computer, close all windows and quit all running
applications that are stored on the USB2.0 External
Drive and drag USB2.0 External Drive's icon into "Trash"
to dismount it from the Desktop prior to unplugging
the USB2.0 External Drive from the USB port.
17
USB Connection