hawa Concepta 50 Planificación Y Montaje página 10

H A W A
Use of the product
Intended use
This furniture hardware is intended for use in protected interior rooms. Install and use in dry rooms only.
Hardware overview
Articles are identified by a five-digit number.
Personnel qualification
Installation work must be carried out by authorised persons only. Authorisation is granted to persons who:
have received training in technical installation or have acquired appropriate experience
•
have read and understood the safety regulations contained in the Assembly Instructions.
•
Assembly notes
The installer is responsible for fastening the hardware at the intended location, such as wall, ceiling, floor, cabinet
body, etc. The installer must define the quantity, dimensioning and load-bearing capacity of the fastening screws to an
extent that ensures the intended load-bearing capacity of the hardware including adequate risk excess is provided.
Furthermore, it must be ensured prior to installing the hardware that the hardware and the attached pivot sliding door
do not exceed the maximum permissible load applicable to the point of installation.
The installer must ensure that with furniture the hardware and the attached sliding door do not exceed the maximum
permissible load applicable to the point of installation. The design of the furniture must ensure it cannot fall over re-
gardless of the door position.
Climatic conditions must be taken into consideration to prevent the corrosion of fastening components.
Use adequate means to prevent any unintentional loosening of fastening screws.
Maintenance and cleaning instructions
No maintenance work is required.
Risk and residual risk
The hardware does not pose any risk or residual risk.
Safety instructions
The symbols for safety-relevant notices (hazard warnings) used in these installation instructions have the following
meanings:
CAUTION
NOTE
Concepta 50
Caution: Identifies a potential hazard of medium risk which may result in
death or (serious) physical injury.
Note: Identifies practical information and tips that enable the best possible
utilisation of machines, installations or devices.
Hawa AG CH-8932 Mettmenstetten
Möbelbeschläge
Tel. +41 44 767 91 91 Fax +41 44 767 91 78
www.hawa.ch
10