Bosch Sensixx B35L Instrucciones De Uso página 21

problem
The appliance
makes a pumping
sound.
loss of pressure
during ironing.
Water spots appear
on the garment
during ironing.
Water spots appear
on the garment
during use of the
"pulseSteam"
function.
The hose gets hot
during use.
Water leakage from
the boiler.
The iron does not stop
steaming after placing
it on the pad (2).
if the above does not solve the problem, get in touch with our customer service.
You can download this manual from the local homepages of Bosch.
* Model dependent
possible causes
• Water is being pumped into the
steam tank.
• The water tank is not fitted onto
the housing correctly.
• The sound will not stop.
Steam release button has been
activated for too long a period of
time, that is, it has been pressed
too frequently.
May be caused by steam
condensed on the ironing board.
Water spots are caused by steam
condensation in the hose when
cooling down after use.
This is normal. it is caused by the
steam passing through the hose
during steam ironing.
Drainage plug located at the
bottom of the appliance is loose.
"pulseSteam" function has been
activated by double click.
Solution
• This is normal.
• Fit the water tank back onto the hou sing
correctly (you will hear a click).
• if the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
Use the steam release button at intervals.
This improves the ironing result as the
textiles will be steamed, dried and ironed
properly.
Wipe the textile cover of the ironing board,
and iron any water drops to dry them.
Water drops stop coming out of the
soleplate after using the "pulseSteam"
function for some time.
place the hose on the opposite side so
that you cannot touch the hose during
ironing.
Tighten up the boiler drainage plug with
a coin.
Just press the trigger once again and the
iron will stop steaming at once.
21
BOS CH