Installing A Paper Roll - Sharp XE-A202 Manual De Instrucciones

A202_1 03.7.5 8:06 AM
4

Installing a paper roll

Precaution: The paper cutter is mounted on the printer cover. Take caution when removing and
The register can print receipts or journals. For the printer, you must install the paper roll provided with the
register, even when you program the register for not printing receipts or journals.
Install the paper roll according to the procedure shown below with the AC cord connected and the mode switch
set to the REG position:
1.
Lift up the print roller release lever to unlock and open the
print roller arm.
2.
Set a paper roll in the paper roll cradle as per the diagram.
3.
Feed the end of the paper along with
the paper positioning guides as per
the diagram.
4.
While holding down the paper, slowly close the print roller
arm, and push down the arm until you hear a click locking
the arm. Make sure securely you push down the center of
the wing part of the arm as per the diagram. The paper will
be fed automatically.
If the print roller arm is not securely locked,
printing is not done right. If this problem occurs,
open the arm, and close the arm as instructed
above.
Page 9
installing the cover.
Print roller
release lever
To the printer
Correct
Paper positioning guides
Print roller arm
To the printer
Incorrect
9