Adjusting The Sound Characteristics; Quickly Attenuating The Sound - Sony CDX-F5500X Manual De Instrucciones

Changing the operative direction
The operative direction of controls is factory-set
as shown below.
To increase
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
Press (SEL) for 2 seconds while
pushing the VOL control.
20
To decrease
Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press the select button repeatedly
until "BAL," "FAD," "LPF" or "SUB"
appears.
Each time you press the select button, the
item changes as follows:
LOW* 1 t MID* 1 t HI*
BAL (left-right) t FAD (front-rear) t
LPF (low pass filter)* SUB (subwoofer volume)*
*1 When EQ3 is activated (page 22).
*2 When "SUB" is selected (page 21).
*3 The cut off frequency is adjustable to 78 Hz,
125 Hz or OFF.
*4 The volume level is adjustable between –10
and +10 steps. (Below –10, "ATT" is displayed.)
2
Rotate the volume control dial to
adjust the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
(With the rotary commander or the card
remote commander)
Press (ATT).
After "ATT-ON" momentarily appears,
"ATT" appears in the display.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
1 t
2 3 t
* 2 * 4