Setup & First Brew; Important; Setting Up Your Coffeemaker - Cuisinart SS-10 Manual De Instrucciones

Setup & First Brew
IMPORTANT: Do not attempt to use
®
your Cuisinart Premium Single-Serve
Coffeemaker until it has been set up for
its first use as outlined below.
Setting Up Your
Coffeemaker
1. Unwrap cord and plug the coffeemaker
into a grounded outlet. Make sure
to remove packing tape, clear plastic
sticker from control panel, and sticker
from water reservoir. Also be sure
to remove the polybag from the
HomeBarista™ Reusable Filter Cup
located in the compartment
on the right side of the coffeemaker.
2. Place a large cup or mug (10 oz. minimum)
on the drip tray.
3. Remove lid from reservoir, then lift
reservoir straight up and away from the
coffeemaker. Wash the reservoir with
warm, soapy water. Rinse well.
4. Fill reservoir with water to the max fill line
and return with lid to unit (see figure 1).
figure 1
5. Press the power switch located on the
right side of the coffeemaker. The
switch is spring-loaded and will return to
original position automatically.
Water Reservoir Lid
Water Reservoir
NOTE: If coffeemaker has been
exposed to temperatures below
freezing, wait at least two hours for it to
reach room temperature before
brewing. An extremely cold
Coffeemaker will not operate.
6. OPEN HEAD and AUTO OFF SET will be
displayed. Open and close the brew head,
READY, AUTO OFF SET and brew-size
icons will now be displayed with the default
size shown as a solid mug (see figure 2).
Ready Mode
7. Making sure your mug is in place, press
the Brew button to start a cleansing
cycle (unit will dispense approximately
8 oz. of water). The control panel will
display BREWING, AUTO OFF SET, as
well as the factory default brew size
(see figure 3). When cycle is complete,
dispose of the hot water.
Note: Do not use a capsule for this cycle.
Also Note: The default AUTO OFF
TIME is set to 30 min. You can change
this in settings (See page 14).
The one-time set-up
process is complete.
figure 3
8
figure 2