Brew Pause ™ Feature; Using Hot Water System - Cuisinart Coffee PLUS CHW-16 Serie Manual Del Usuario

4. Position carafe and plug in unit
Place carafe on heating plate and be sure
the coffeemaker lid and water reservoir
cover are closed. Plug coffeemaker into an
electrical outlet.
5. Set preferences
a. Push the 1–4 Cup button if you are
brewing fewer than 5 cups.
b. Turn the Carafe Temp button to Low (L),
Medium (M), or High (H) and heater plate
will keep coffee at the temperature
you select.
6. Start Brewing
Press the Brew/Off/Auto Off button to begin
brewing.
7. After brewing
When the brewing cycle has been completed,
5 beeps will sound. Coffee will continue to
stream from the filter for several seconds.
NOTE: Reservoir cover may be hot during
and directly after brewing. Wait at least 10
minutes before opening.
BREW PAUSE
This feature interrupts the flow of coffee from
the basket to let you pour that first cup mid-
brew. Because the flavor profile of coffee
brewed at the start of a cycle differs from that
brewed toward the end, be aware that using
this feature will weaken the flavor strength of
the finished pot.
NOTE: Removing carafe for more than 20
seconds may cause filter basket to overflow.
USING THE HOT
WATER SYSTEM
Follow instructions in Before First Use on page 7.
1. Insert charcoal water filter
Follow directions for the preparation
and insertion of the filter on page 8.
2. Fill the hot
water reservoir
Open the water
reservoir cover by
lifting it up. Fill the
hot water reservoir
with water, making
sure not to fill
above the max
fill line.
FEATURE
™
3. Heating
Press the Hot Water On/Off button. The Hot
Water On/Off button indicator light will
illuminate. The Water Ready indicator will
flash while the unit is heating. Once the unit
has heated, the Water Ready indicator will
become solid.
4. Dispensing water
To dispense water, be sure the safety switch,
which is located below the dispensing lever,
is in the unlocked position. Simply slide the
safety switch to the left to unlock. Then place
a cup on the drip tray and press the lever
down – the unit dispenses up to 13 ounces of
hot water at a time. If desired, return the safety
lock to the locked position (to the right) after
dispensing water.
NOTE: You can remove the drip tray to
accommodate tall mugs.
5. After dispensing
The heater will immediately begin heating
more water. The Water Ready indicator will
again flash until water reaches serving
temperature.
NOTE: The Add Water indicator will appear
in the display if more water is needed.
6. Turning off Hot Water System
To turn off your Hot Water System at any
time, press the Hot Water On/Off button. The
indicator will turn off, but the Water Ready
indicator will remain lit until water has cooled
below serving temperature.
9