GreenWorks Commercial GBB 700 Manual Del Propietário página 13

ASSEMBLY
REMOVING THE DUST COVER (See Fig 7.)
1. Unlock the latches on both sides to release the dust cover.
2. Remove the dust cover to expose the battery compartment.
Please keep the battery cap installed to prevent entry of dust or water.
NOTE:
BATTERY
IMPORTANT! The battery pack is not charged when it is purchased. Before using the blower for
the first time, place the battery pack in the battery charger and charge. Make sure to read all safety
precautions, and follow the instructions in the Battery Charger section.
To Remove (See Fig 7.)
1. Press and hold the battery release button (K) with firm grip.
2. Grasp the backpack firmly. Pull the battery pack out of the compartment.
The blower can hold two batteries, but only one of the batteries works during operation.
NOTE:
To Install (See Fig 7.)
1. Align the battery pack with the cavity in the backpack housing.
2. Insert the battery pack into the backpack housing.
3. Grasp the backpack firmly.
4. Push the battery pack into the backpack until it locks into place. You will hear a click once it
is locked into place.
5. Do not use force when inserting the battery pack. It should slide into place and click.
K
W A R N I N G
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the blower.
• Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
Latch
1
13
Dust Cover
Fig. 7